EDNA Installation & Printer Setup


EDNA (Electronic Device Native Adapter) is Traxia's software for printing receipts and labels through SimpleConsign. If you will not be printing on Avery labels, you'll need to download and install EDNA. Then you'll need to configure your printers.

I'm not technical!

If you're not quite confident in setting up your printers, please don't hesitate to contact us at (888) 860-8094 and follow the prompts for support. We can help you from there :)

On this page

Installing EDNA

  1. 1.
    Log into a terminal and navigate to the Admin tab
  2. 2.
    Click the Download button
  3. 3.
    Run the installer that downloads and complete the installation wizard

Configuring Printers

  1. 1.
    After installing EDNA, refresh SimpleConsign and click the Printers option on the top right corner of the screen
  2. 2.
    In the Printers window, navigate to the EDNA Printers tab. You should see your printers listed.
    No 'EDNA Printers' tab?
    It can take a minute or so for EDNA to be fully operational. Refresh your browser and check again. If you're still not seeing this tab after 5 minutes, please contact Support at (888) 860-8094
  3. 3.
    Next to each of your printers, click the Add Printer link
  4. 4.
    Name the printer as you desire or leave what has been automatically filled in
  5. 5.
    Click the Add _____ Printer button to finish configuring this printer
  6. 6.
    Repeat steps 2 through 5 for all printers you have
  7. 7.
    Go back to the Printer Mapping tab
  8. 8.
    Assign your printers appropriately using the RECEIPT PRINTER and LABEL PRINTERS dropdowns
  9. 9.
    For some labels we offer variations of text sizes and layouts. If available you can find and choose them here
  10. 10.
    That's it! Simply close that window and you're ready to print!

But how do I print?

Here's our page for Printing Consignment Labels.